Windows Credential Provider for Windows 10 installation guide

Note: This integration does not support the use of Push. You will need to use OTP.


Prerequisites

Microsoft Visual C++ 2015 redistribution package. This update can be downloaded here.

Microsoft .NET v4.6.1. This update can be downloaded here.

 

Supported Platforms

The AuthAnvil Two Factor Auth Windows Credential Provider is available for the following platforms:

  • Windows 7Pro (32bit, 64bit)
  • Windows 7Ult (32bit, 64bit)
  • Windows 8Ult (32bit, 64bit)
  • Windows 8.1Ent (32bit, 64bit)
  • Windows 10Pro (32bit, 64bit)
  • Windows 10Ent (32bit, 64bit)
  • Windows Server 2008
  • Windows Server 2008r2
  • Windows SBS 2011 
  • Windows Server 2012
  • Windows Server 2012r2

Note: This guide is only applicable to the following installers

Windows Credential Provider Supporting Windows 10 - 32 Bit installer.
Windows Credential Provider supporting Windows 10 - 64 Bit installer

 

Installation

Once downloaded. Run the MSI installer.

Note: A reboot of the machine may be required for the logon prompt to be displayed

Note: You can run not run an MSI elevated, however you can run an MSI from an elevated command prompt.

Select Next.

Accept the Terms of use and select Next.

Update the SAS URL to reflect your AuthAnvil FQDN. Your SAS URL will be your tenant URL/AuthAnvil/SAS.asmx Example https://acme.my.authanvil.com/AuthAnvil/SAS.asmx

Once you have the correct SAS URL select Next.

Set the Override Group and Override password.
Note: This Override Group will need to be manually created in Active Directory or locally for stand alone machines.
Note: Always set an override Password to prevent errors during installation and testing. This password can be changed later as well.

Select Next once the Override settings are set.

Select Install to complete the setup. 

Once the system is reboot you should now see a Windows Logon prompt including an AuthAnvil passcode prompt.

Testing functionality

When the user logs into a Windows Desktop locally or remotely they will see the following.

The AuthAnvil Passcode consists of a Pin+OTP.

Note: Users will need to enter a four digit pin here as well as the One Time Password.
For the Pin your users will use Pin: 1234
The actual Pin requirement was a hold over from the old On-Prem configuration. On-Demand does not use the Pin, however it respects the value being submitted.

Advanced configurations

See this article for advanced setup options.

Note: Offline caching mode is currently not compatible with AuthAnvil On-Demand user accounts.

Have more questions? Submit a request

0 Comments

Article is closed for comments.